Linux KVM: Disable virbr0 NAT Interface

The virtual network (virbr0) used for Network address translation (NAT) which allows guests to access to network services. However, NAT slows down things and only recommended for desktop installations. To disable Network address translation (NAT) forwarding type the following commands:

Display Current Setup

Type the following command:
# ifconfig
Sample outputs:

virbr0    Link encap:Ethernet  HWaddr 00:00:00:00:00:00  
          inet addr:  Bcast:  Mask:
          inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:39 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:0 (0.0 b)  TX bytes:7921 (7.7 KiB)

Or use the following command:
# virsh net-list
Sample outputs:

Name                 State      Autostart
default              active     yes       

To disable virbr0, enter:
# virsh net-destroy default
# virsh net-undefine default
# service libvirtd restart
# ifconfig


- TIBCO Consultant. - Linux Lover. - Active Blogger. - DevOps Supporter

Leave a Reply

Please log in using one of these methods to post your comment: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s